Ultrasonic emulsification machine in the process of running ultrasonic emulsifying machine efficiency is very high. Machine with long time, also needs corresponding maintenance. As for the maintenance, small make up will tell you how to adjust the frequency of the welding machine.
Tuned before, need to check whether locking between ultrasonic mould and ultrasonic horns, if not, lock first. Also note that during the period of tuned, don't let the welding head contact with other objects.
Open the machine power supply, power indicator.
Find the ultrasonic test switch on the machine, press, pay attention to the sheet at the same time. If the ammeter pointer by more than 30% of the range or value is greater than 2 amp, press the switch test time is short, otherwise you will cause damage to the machine. Observing sheet, at the same time adjust the tuning inductance, spin around, until the value of the instrument shows that at least stop position. Generally between 5% and 15%, value of 300 m.
For machines with screens, the tuning range of inductance Ultrasonic emulsifier machines usually only 360 degrees. When the welding head frequency is large, need to adjust. At this point, the need to open the lid, open fixed device reset.
You can find resonance of the ultrasonic plastic welding machine operation is very simple, because the machine itself has set this function, so you only need to pay attention to in practice operation as required.
Harmonic note:
1) adjust the tuning inductance, change the size of the load ultrasonic extraction cbd tables do not represent the size of the power output, only on behalf of the generator and the degree of the transducer can implement system of resonance (voltage is smaller, the better the resonance). (switch to adjust amplitude can be adjusted, but can't adjust the output of the ultrasonic amplitude adjustment switch, in case of high voltage electric shock.
When load table light, said resonance degree; Load, said the output energy.
3) tuning, if overload indicator, should immediately release test switch. After three seconds, adjust the tuning inductance, then in ultrasonic testing.
4) correct coordination is very important. If can not meet the normal case, please refer to the fault detection table, not reluctantly or use, so as not to damage the machine.